Those things can sometimes be easily fixed.Ĭheck the bluing of the barrel. If there isn't enough clearance, the hammer will strike the edge of the cap and may not detonate every time. The hammer has to strike the cap cleanly and not on the edge. Think about the thickness of a percussion cap. It just has to clear the rim of the cup of the hammer with a little extra room. You should or might see a slight mark in the cup of the hammer where it strikes the nipple. I don't know what Jukar did.Īs for the hammer, it should hit the nipple squarely. Thompson Center marked their barrles with the letter 'K' to indicate kit. Again, it just depends on the care put into it during the building. Some kit guns can perform just as well or better than factory guns. If it is a kit, and the builder put it together with a lot of care, it might be difficult to tell the difference. Factory guns are generally finished a little better than some of the earlier kits guns I have seen. Look at the wood to metal fit and finish. If there is any paperwork that comes with the rifle(s), there might be some information regarding a kit build. I would ask the seller if the guns are from kits. If the barrels are good, my experience is they have been good shooters.ĭid you happen to notice the caliber of the rifles? Some things can be not so attractive, but work very well. It might be something very close to what is currently being offered by Traditions. Check the nipple to see if it is pounded flat and needs to be replaced. And look under the hammer face into the small cup of the hammer. Is the trigger a piece of steel or is it brass? Check the brass furniture, nose cap, trigger guard, buttplate, ramrod thimbles, side plate or washers, patch box if any. It can be a double trigger or most likely a single trigger. Kit guns can be built very well, and some not so well.Ĭheck the trigger. Are the stocks made in two pieces with a brass 'washer' at the joint between the two pieces of wood? Check to see if they are kit guns or factory finished rifles. If they don't have the bridle, they are a cheaper version of the lock. Check the back side of the locks to see if they have a bridle over the tumbler, and a fly in the tumbler. If they are percussion rifles, look for rust or pitting around the nipple. Run a patch down the barrel and see what you get to come out. It might be the previous owner goofed something and bulged the barrel. You can run your hand down the exterior of the barrel and maybe feel for a bulge, or look down the bore and you will see a ring around the inside of the bore. I would check the barrels for obvious signs of abuse or neglect, pitting or rust.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |